Hato Polyguard

1 Gallon, 1/4 Gallon
  • Features
  • Surface preparation
  • Coating system
HATO Polyguard is a mixture of 2 parts protecting surface and structure from erosion or rust. Part A is made from polyamide resin and coal-tar pitch. The hardener in part B is made from epoxy resin. Paint dries from the reaction between part A and B. Dried film provides adhesion to surfaces like metal, concrete, and fiberglass. It offers great solidity, durable to bending, hitting, rubbing, chemicals which are acid, alkaline, seawater, polluted water, moisture, and extreme weather conditions.

  • The thick film provides excellent substrate anti-rust
  • Strong adhesion and anti-flaking
  • Great solidity, durable to bending, hitting and rubbing
  • Durable to sun and rain and extreme weather conditions


Number

PL200 Grey, PL800 Green
All Surfaces Remove all dirt, grease, oil, salt, and chemical contaminants. Mold and mildew areas must be cleaned with a chlorinated cleaner or bleach solution.
Rinse thoroughly with freshwater and allow to fully dry. All surfaces must be dry at the time of application.
Steel Surfaces should be blast cleaned to a near-white finish using a suitable abrasive. And/or by using the surface preparation with requirements. of the primer and/or as the Spec of the project. The surface must be thoroughly dry and apply the protective coating within 4 hours
Concrete
(Immersion)
Hand or power tool clean to remove all loose or unsound concrete, masonry, or previous coating.


  • Mix Part A and Part B strictly follow mix ratio PART A 4 : PART B 1
  • Recommendations before dilute by Thinner mixing and stir for 2-3 minutes until the mixture is homogeneous then leave 5 minutes before application
  • Pot life (at 25๐C) 6 Hours after mixing PART A with PART B, pot life is reduced at higher temperatures